And the black hardware beautifully contrasts with the red cedar.
Tongue and groove gate plans.
Plus the tongue and groove cedar boards ensure privacy as no one will be able to peek through slats in the gate.
Match the tongue on one board with the groove on the other board.
Reset the height of the table saw blade to 3 8 inch set the fence at 3 4 inch and cut the face of each short side of each board.
To produce the tongue the spindle block is lifted and then the boards go through face down.
The gate we are making is made from treated sawn timber planks which are 100mm wide and 25mm thick.
Use a 3 4 inch chisel to clear out any material in the groove.
This project provides instructions to create a 42 inch wide cedar wood gate that will add style and function to a fence.
Flip the boards over and repeat on the other face.
Step 2 run a bead of glue inside the all the grooves using the tip of a glue bottle.
This timber is called 4 x 1 treated timber in the builders yards and timber merchants where you will find it is a lot cheaper than places like homebase and b q.
For a gate approx 1m wide ours was actually 900mm you will need 5m.
Next with the tongues and grooves on all the boards grab the board with only a tongue moulded on and the board with only a groove within it as we need to run a chamfer on the.
Unfinished pine tongue and groove shiplap siding board 6 pack model 276588 view the ufp edge unfinished tongue groove.