Turn Of The Century Ceiling Fan Remote Not Working

To determine the cause of the fan speed malfunction follow the steps below.

Turn of the century ceiling fan remote not working.

One way to know for sure would be to remove the receiver module at the ceiling fan and wire it direct. You also have to ensure that the batteries are in their right position. Clean and lubricate the ball bearings. Replace the ceiling fan capacitor.

If the ceiling fan and light works normally then the remote control module will need to be replaced. Turn off the ceiling fan using the remote wait for about 30 seconds before turning the power on within those seconds hold down the off button on the fan for about ten seconds the steps should allow you to perform a reset. Should it become necessary to re sync the remote turn off the main power then turn it back on. I called hunter and they sent a new controller for ceiling fan i installed that and light would still not work.

I changed the light bulbs and still no light. The fan will turn on and light if applicable will blink three times signaling a successful synchronization. If your ceiling fan won t turn on or your speed settings are not working properly you may notice a sharp change in the airflow. If you are use a remote control to start your fan check your batteries and have them replaced.

As strange as it sounds your ceiling fan could have stopped working because there is a problem with the remote control. It worked great until recently now the light and the fan will not turn on.